Owner's Manual

INSTALLATION INSTRUCTIONS

Rear USB Inputs

Two USB connector cables are located at the rear of the radio

body. During installation, you must route the cables to an

accessible location.

NOTE:

If the USB cables provided are not long enough, you may use our USB/AUX

Extension Cable (sold separately) to extend the reach of one cable. This cable also allows

the installation of one USB and auxiliary port into the factory location of the cigarette

lighter for a factory look and easy access.

SiriusXM Input

The SiriusXM input is located at the rear of the radio body. Instructions

for wiring and installing your SiriusXM Connect vehicle tuner are

included with your SiriusXM Connect vehicle tuner box.

STEP 5: Finish the Installation

IF USING A BEZEL, place the bezel on the face of the radio, then install

the assembled radio from behind the dash until the bezel and radio

face are ush with the front of the dash and the radio shafts protrude

through the shaft openings in the dash. Using the supplied washers

and shaft nuts (see “What’s In the Box” on page 4), secure the radio

to the dash.

IF USING A FACEPLATE, slide the radio into the hole from behind the

dash, then align the faceplate over the radio shafts from the front.

Using the supplied washers and shaft nuts (see “What’s In the Box” on

page 4), secure the faceplate to the dash and the radio.

DAMAGE RESULTING FROM OVERTIGHTENING THE SHAFT NUTS

WILL VOID YOUR WARRANTY.

Finally, you’ll need to secure the rear of the radio using the supplied

backstrap and hardware (see “What’s in the Box” on page 4). The

backstrap mounts using the threads in the rear of the radio body and

can be bent and adjusted to align with the mounting point of the

original factory radio behind the dash. Now you can install your knobs.