Owner's Manual

PRECAUTIONS

• Refer wiring and installation to qualied service personnel.

Installation of this unit requires special skills and experience.

Retro Manufacturing, LLC is not liable for any problems resulting

from improper installation of the unit. Please be sure to follow

the instructions carefully while attempting installation.

• Follow the instructions to wire the unit. Failure to follow the

instructions could cause damage to the unit, re, injury or death.

• Be careful not to damage the leads. Prevent them from

being caught in the vehicle chassis or from being damaged

by screws or moving parts such as seat rails. Do not scratch,

pull, bend or twist the leads. Do not install them near heat

sources or place heavy objects on them. If the wiring must

be routed around sharp metal edges, protect them by

wrapping them with vinyl tape or similar protections.

NOTE: Cutting the main wiring harness, antenna lead,

USB or auxiliary cables will void the warranty of your radio.

• We recommend only using the designated parts and

tools when installing this unit. If mounting the radio face

or body remotely, use extreme caution not to damage

internal parts when choosing brackets and screws.

• Do not interfere with safety-related vehicle components.

Do not wire or afx this unit to the fuel tank, brakes,

suspension, steering wheel, pedals, etc. Check for electric

wiring, piping and other items before installing the unit.

• Never install the unit in a location where it

interferes with your eld of vision.

• Use the supplied metal backstrap to secure the rear

of the unit. Failure to secure the back of the unit will

damage the shafts and void your warranty.