Installation Guide

Soft-Close Vanity Pullout with
Tandem slides with BluMotion
T-445VBSC-1214
Center line of Cabinet Opening
Recommended Screw and Pilot
Hole Location (4) Places
* Fold Template along
this edge to t
cabinet opening.
* Use this side for
8” wide pullout
Front edge of paper
to front of cabinet
(or front of face frame)
TOOLS REQUIRED:
ESTIMATED ASSEMBLY
TIME:
30 MIN
CARE AND MAINTENANCE:
CLEAN WITH A DAMP CLOTH
AND WIPE PARTS DRY
PARTS LIST:
FRAME/SLIDE ASSEMBLY
4 #6 X ½” FLAT HEAD SCREW
4 #8 X ¾” DEEP THREAD PAN HEAD SCREW
TEMPLATE
ADJUSTABLE RUB BUSHING KIT
3/32”
Attaching slide to cabinet
1) Remove frame from slides. Reach under front of frame and squeeze release levers on both sides.
Lift frame up and slide forward then set aside.
2) Using the mounting template locations, pre drill 4 holes using a 3/32” drill bit.
3) Remove template and attach the slide assembly to the oor of the cabinet using (4) #8 x ¾” deep thread screws provided.
4) With the slides in the fully closed position, place the frame on the slides and push back until you feel the slides engage the locking devices
(you will hear a click sound). Fully cycle the frame a few times.
Attaching the cabinet door
1) Loosen the (4) lock nuts (3/8” wrench) inside the front wall of the unit. (See Fig 1)
2) Pull the Adjustable Door Mounting Brackets to ensure that you are mounting to the “thick” portion of the cabinet door. (Front of pull out
should line up with front of face frame).
3) Use the (4) #6 x ½” at head screws provided to attach the door to the pullout unit.
4) If the door needs to be tilted to lay ush against the face frame, loosen the 8mm nuts and turn the “T-Nut” screws so that it pushes against
the metal bracket. Each corner can be adjusted independently. (Note: It is recommended that door bumpers be used on each corner to
ensure quiet operation)
Install rub bushings using enclosed kit and instructions (Note: Chassis may need to be removed for proper installation)
Fig 1
T-Nut Screw for
Tilt Adjustment
Lock Nut
Use this side for 8” wide pullout
12400 Earl Jones Way • Louisville, KY 40299
[phone] • rev-a-shelf.com