Installation Guide

NEW mounting brackets adjust up to 5" so they will align in thick portion
of door frame. (Standards may have to be cut to fit shorter doors.)
STEP 1: Figure 1
Measure center (top) to center (bottom) on inside door frame rails.
STEP 2:
Transfer measurement from STEP 1 to standards and tighten screws.
STEP 3:
Remove door from cabinet and lay face down on a towel to
protect finished surface.
STEP 4: Figure 2
Mark center line of door (side to side)
STEP 5: Figure 3
Position one standard on back of door with slats pointed towards top of
door.
STEP 6: Figure 4
Align standard parallel to edge of door using spacing according to
Dimension “B”.
STEP 7:
Fasten to door panel frame using screws furnished.
CAUTION: Determine thickness of door panel and make sure
screws are not too long and do not come thru front of panel.
STEP 8:
Repeat STEP 6 with other standard. Make sure bottom of both
standards are level with each other so shelves hang level.
STEP 9:
Replace door to cabinet and hang spice shelves on standards.
Instructions for Adjustable Spice Racks
READ THIS FIRST!
NOTE:
The standards can be moved
side to side if necessary to clear
hardware or partition so shelves will
clear opening as door swings open.
2409 Plantside Drive
Jeffersontown, KY 40299
502-499-5835 • FAX: [phone]
www.rev-a-shelf.com
Back of Door Side Profile
Figure 4
Center
Line
B
4
1
/2" 4ASR-15
6" 4ASR-18
7
1
/2" 4ASR-21
Front Face
Frame
Figure
1
Figure
3
Cabinet
Floor
Figure
2
Door Frame
Top
Door Frame
Bottom
I-4ASRC 11-05