Installation Guide

Installation Instructions for:
RV-Series
Pull-Out Waste Containers and Hampers
With the frame in a closed position, insert the front two
screws, making sure that the framework is square to the
front of the cabinet.
If there is suf cient clearance, install rear screws.
If framework prevents access to rear screws, remove
framework by pulling out and lifting frame from slides.
Note: if your product features full extension slides
remove frame by disengaging release triggers (Fig. A).
Finally, place your waste container in the wire frame and the
installation is complete.
Your RV series has been shipped fully assembled for ease
of installation.
• First Remove the container(s) from the wire frame.
• Place the frame inside of your cabinet.
• Look to make sure that there is plenty of clearance to
shut the door and for the waste container.
I-RV-05
©2005 Rev•A•Shelf, Inc. • 2409 Plantside Drive • Jeffersontown, KY 40299 • 1-800-626-1126 • FAX [phone]
1
2
3
FIGURE A
If you have any questions or would like additional information
on the rest of our prod ucts for the kitchen, closet, or
bathroom, please contact a Customer Service Specialist at:
1-800-626-1126 or visit us on the web at www.rev-a-shelf.com.
Also, don't forget about our door mount kit (RV-DMKIT)
that will attach your current cabinet door to your RV Waste
Container or Hamper.
1
2
3