Owner's Manual

6
Loudspeaker
Owner’s Manual
ADJUSTABLE FEET ON C25
C25 loudspeakers include two sets of adjustable feet, one short and
one long that let you angle the loudspeaker up or down so it is aiming
towards listeners’ ears when it is installed above or below a TV display.
The feet screw into the threaded inserts on the bottom of the speaker.
• To tilt the loudspeaker upward, install the set of short feet into the
front threaded inserts on the bottom of the loudspeaker. Install the
long feet on the back so that the loudspeaker achieves a level balance.
Rear
Inserts
Front
Inserts
• To aim the loudspeaker straight forward (with no tilt), install the set
of short feet into the front threaded inserts on the bottom of the
loudspeaker and the long threaded feet on the back inserts. Adjust
the feet so that the loudspeaker achieves a level balance.
• To tilt the loudspeaker downward, install the set of long feet into the
rear threaded inserts on the bottom of the loudspeaker. Adjust the
feet so that the loudspeaker achieves a level balance.
Upward Tilt
Short Feet in
Front Inserts
No Tilt
Short Feet in
Front Inserts
Long Feet in
Rear Inserts
Downward Tilt
Long Feet in
Rear Inserts
ADJUSTABLE SPIKES ON FLOOR STANDING SPEAKERS
Four adjustable spikes are included for each F35 and F36 loudspeakers.
You can install these spikes in the bottoms of the loudspeaker cabinets
to provide optimal stability, accommodating installations on tile,
hardwood, and carpeted floors.
To install and adjust the spikes:
1. Place the loudspeaker on its side on a soft towel or carpeted floor.
2. Screw the spikes into the fittings on the bottom of the loudspeaker.
The spikes can be installed with either the pointed end or round end
protruding from the cabinet.
• If the loudspeakers are to be placed on a carpeted floor, install the
spikes with the pointed ends protruding from the cabinet.
• If the loudspeakers are to be placed on wood, linoleum or tile floor,
install the spikes with the round ends protruding from the cabinet.
After determining the final locations for the speakers you can place
coins under the spikes to protect the floor surface from damage.
Pointed
End Out
• If you wish you can install the spikes with the pointed ends
protruding from the cabinet for placement on wood, linoleum or tile
floors. In this case you must place coins or similar items under the
spikes to avoid damaging the floor surface.