Revel B8 Wireless Subwoofer Owner’s Manual
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. 9.
INTRODUCTION INCLUDED ITEMS Wireless Subwoofer THANK YOU FOR CHOOSING THIS REVEL PRODUCT! Transmitter Module Your new Revel B8 200-watt powered wireless subwoofer incorporates an 8" (200mm) down-firing cone transducer and a built-in, high-performance, 200-watt amplifier that delivers the powerful, dynamic and accurate low-frequency performance that makes your film soundtracks and music come alive.
SUBWOOFER UNIT TRANSMITTER UNIT Phase switch: This switch determines whether the subwoofer transducer’s piston-like action moves in and out in phase with the satellite speakers. If the subwoofer were to play out of phase with the satellite speakers, the sound waves from the satellites could cancel out some of the subwoofer’s sound waves, reducing bass performance and sonic impact. This phenomenon depends in part on the placement of all the speakers in the room.
CONNECTING THE SUBWOOFER CONNECTING THE SUBWOOFER TO A RECEIVER OR PREAMP/ PROCESSOR WITH A DEDICATED SUBWOOFER OUTPUT WIRELESS: DC 5V WIRELESS CODE 1 Power Supply AC Cord 2 Power Supply 3 4 R INPUT L Use either connector LFE Cable (supplied) SUBWOOFER/ LFE OUT Set Input Mode Switch to “LFE” 1. C onnect the supplied LFE cable from your receiver’s or processor’s subwoofer output to either of the transmitter unit’s Input connectors.
CONNECTING THE SUBWOOFER TO A RECEIVER OR PREAMP/ PROCESSOR WITH LINE OUTPUTS CONNECTING THE SUBWOOFER TO A TRIGGER VOLTAGE SOURCE Trigger Cable (supplied) Set Input Mode Switch to “Normal” LINE-LEVEL OUTPUTS L R Stereo RCA Cable (not supplied) The subwoofer will automatically turn on if it receives a trigger voltage at its External Trigger Input connector and will enter the Standby mode when the voltage ceases.
WIRELESS OPERATION When the wireless transmitter receives an audio signal from the source, it will immediately turn on and the status LED will change to flashing green or solid green: Green (flashing): Transmitter is on but has not established a link with the wireless subwoofer Green (solid): Transmitter is on and has already established a link with the wireless subwoofer.
LIMITED WARRANTY Revel loudspeakers are warranted against defects. The duration of a warranty depends on the laws in the country in which it was purchased. Your local Revel retailer can help you determine the duration and coverage of your warranty. For more information please visit: REVELSPEAKERS.COM Please visit REVELSPEAKERS.COM for additional language support on the user manual. Veuillez visiter REVELSPEAKERS.COM pour obtenir le mode d’emploi en d’autres langues.
Торговая марка: Revel Назначение товара: Пассивная акустическая система Изготовитель: Харман Интернешнл Индастриз Инкорпорейтед, США, 06901 Коннектикут, г.Стэмфорд, Атлантик Стрит 400, офис 1500 Страна происхождения: Китай Импортер в Россию: ООО Внешторг-Юг, Россия, 171640, Тверская область, г.Кашин, ул. Карла Маркса, д.57A Гарантийный период: 1 год Информация о сервисных центрах: http://absolut-audio.ru/Servis/ тел.
Revel B8 Features • 8" down-firing cone transducer • Built-in high-performance 200-watt RMS amplifier • Wireless 2.
Revel B8 10.5" (267mm) 12" (305mm) 13.9" (353mm) 10.5" (267mm) 4.9" (125.6mm) 3.1" (79.7mm) 1.3" (32.5mm) HARMAN International Industries, Incorporated 8500 Balboa Boulevard, Northridge, CA 91329 USA www.jblsynthesis.com 1.2" (31mm) © 2018 HARMAN International Industries, Incorporated. All rights reserved. Revel is a trademark of HARMAN International Industries, Incorporated, registered in the United States and/or other countries.
IMPORTANT SAFETY INSTRUCTIONS Fer all products: 1. Read these instructions. 1 leepthesetnstructions. l. Heed all wamllgs. follow al lftstrucllons. Do not use this apparatus near water. Cleaa o,lly with adry doth. Do not block any ventilation openings. Install this apparatus in accordance with the IIIIIIUfacbnr's lnstnKtions. ~ Do not lmtall this apparatus near-, heat sourtes such as radiatDls, heat registers, -.s orotllel' apparatus (induding ampllfiers) that produce heat 9.
CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN. A A THE LIGHTNING FLASH WITH AN ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE"WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE ARISK OF ELECTRIC SHOCK TO PERSONS.
FCC/IC Radiation Exposure Statement This equipment complies with FCUIC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. For Wi-Fi SG device FCC Caution: High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and/or damage this device.
For Products with Radio Receivers That Can Use an External Antenna {USA ONLY): manual carefully and retain it for future use. Should the unit require maintenance or repair, please contact your local Revel service center. Refer servicing to qualified personnel only. CATV (Cable TV) or Antenna Grounding If an outside antenna or cable system is connected to this product, be certain that it is grounded so as to provide some protection against voltage surges and static charges.
WEEE Notice The Directive on Waste Electrical and Electronic Equipment (WEEE), which entered into force as European law on 14/02/2014, resulted in a major change in the treatment of electrical equipment at end-of-life. The purpose of this Directive is, as afirst priority, the prevention of WEEE, and in addition, to promote the reuse, recycling and other forms of recovery of such wastes so as to reduce disposal.
(140°F), or dispose of in fire or water. Replace only with specified batteries. The symbol indicating 'separate collection'for all batteries and accumulators shall be the crossed-out wheeled bin shown below: 2014/30/EU Directive, LVD 2014/35/EU Directive, ErP 2012/27/EU Directive and RoHS 2011/65/ EU Directive. The declaration of conformity may be consulted in the support section of our Web site, accessible from www.revelspeakers.com.
HARMAN HARMAN International Industries, Incorporated 8500 Balboa Boulevard, Northridge, CA 91329 USA ~*flrt!! , lrfflrt!!fDtHIDftrth~lH1H~ 0.0005 %akJffi: , ffl~ 0.002 % akJ ~9-XJliiiH~ 0.004 % ak)ffi • IJ!~f!J=Ffii~fflitliakJ{t~r.f~ : '.Jt~IJ~ Hg ' Cd~ Pb O ~'1~!fflT9IJf,f!JJJc : s16.S94.o3oo (fl~N~~) HARMAN International Industries, Incorporated. f~~--17.
