Owner's Manual

Revel PerformaBe C426Be Loudspeaker

Owner’s Manual

LOUDSPEAKER PLACEMENT

We recommend that you remove all obstructions between the loudspeaker and the primary

listening position. For instance, a coffee table between the loudspeaker and the primary

listening position will create reﬂections that will degrade timbre which can make ﬁlm dialog

more difﬁcult to understand. Placing the loudspeakers near large objects may also cause

unwanted reﬂections.

STAND-MOUNTING

A pedestal stand, table, or cabinet will place the C426Be at the proper height for installation

below a TV display.

FLUSH-MOUNTING

When ﬂush-mounting the C426Be inside of a cabinet or entertainment center:

• Make sure that the front of the loudspeaker is ﬂush with the front edge of the mounting

shelf and surrounding surfaces.

• If necessary to aim the loudspeaker directly at the listeners’ ears, use the supplied

long feet to angle the loudspeaker down if it is placed above the TV display, or use the

supplied short feet to angle the loudspeaker up or straight forward if it is placed below

the TV display. See Adjustable Feet, on page 5.

ADJUSTABLE FEET

C426Be loudspeakers include two sets of adjustable feet, one short and one long that let

you angle the loudspeaker up or down so it is aiming towards listeners’ ears when it is

installed above or below a TV display. The feet screw into the threaded inserts on the bottom

of the speaker. Also included is a set of levelers that screw into the feet for added tilt.

•

To tilt the loudspeaker upward, adjust the front threaded feet downward so that the

loudspeaker achieves the desired level balance.

• To aim the loudspeaker straight forward (with no tilt), remove the front threaded feet

so that the rubber bumper rests on the seating surface. Adjust the rear threaded feet

downward so that the loudspeaker achieves the desired level balance.

• To tilt the loudspeaker downward, remove the front threaded feet, rubber bumper and

foot support. Reinstall the front rubber bumper and threaded feet until snug to the

loudspeaker bottom. Rest the front rubber bumpers on the seating surface. Adjust

the rear threaded feet downward so that the loudspeaker acheives the desired level

balance.

Feet in Front Inserts Feet in Rear Inserts Feet in Rear Inserts

Upward Tilt

No Tilt

Downward Tilt

Foot Support

(2 Front/2 Rear)

Threaded

Feet

Rubber

Bumper

Foot Assembly Detail