Owner's Manual

Revel PerformaBe C426Be Loudspeaker

Owner’s Manual

C426Be SINGLE-WIRED CONNECTION

Note: Do not remove the shorting straps between the speaker terminals.

Single-wired connections are the most common. These are made between one pair of

C426Be input terminals and one power ampliﬁer output channel as shown below.

Ampliﬁer

(one channel shown)

C426Be

Connector Panel

Do NOT

Remove

Shorting

Straps

To make single-wired connections, connect one loudspeaker cable to the desired set of

C426Be input terminals. (The high-frequency – “HIGH” – input terminals are recommended.)

Then connect the other end of that loudspeaker cable to the desired power ampliﬁer output

channel.

C426BE BI-WIRED CONNECTIONS

CAUTION: Remove the shorting straps before making bi-wired connections. Failure to

do so may cause damage to some power ampliﬁers.

Bi-wired connections use two sets of loudspeaker cables to connect both sets of C426Be

input terminals to a single power ampliﬁer output channel as shown below.

Ampliﬁer

(one channel

shown)

Shorting

Straps

Removed

C426Be

Connector

Panel

Use Both

Sets of

Terminals

1. Remove the shorting straps.

2. Connect one loudspeaker cable to the high-frequency set of C426Be input terminals.

Then connect the other end of that loudspeaker cable to the desired power ampliﬁer

output channel.

3. Connect another loudspeaker cable to low-frequency set of C426Be input terminals.

Then connect the other end of that loudspeaker cable to the same power ampliﬁer

output channel that you connected in step 2.