Revel® CONCERU, STANDM10 Owner's Manual REVEL:
Installing the STANDM10 Loudspeaker Stand Step One Remove the bottom end cap of the speaker by unscrewing the single center screw (Allen wrench included with satellite). Note: The bottom is the end closest to the Revel logo on the front grille. End cap-- , ~ 1/4-20 x 3/4" Screw----- ' Step Two Attach alignment pin to stand, and run speaker wire up stand. Note: Needle-nose pliers may be required. f ~-Alignment pin ~-- - 2 Step Three Align and insert the alignment pin into the bottom of the speaker.
Step Four Tighten the bolts on the bottom, as shown. It is recommended that two people perform this step so that the speaker is supported while it's on its side and the bolts are being tightened. Attach the f3peaker wire as described in the Revel®Concerta'" M1 Oowner's manual.
Revel, the Revel logo and Concerta are trademarks of Harman International Industries, Incorporated, in the United States and/or other countries. Features, specifications and appearance are subject to change without notice. REVEL: www.revelspeakers.com 250 Crossways Park Drive, Woodbury, NY 11797 8500 Balboa Boulevard, Northridge, CA 91329 516.594.0300 Technical Support: 516.682.3744 Part No. ML-SP0087-01 ©2008 Harman International Industries, Incorporated. All rights reserved.
