FAQ

models RVL50, RVL70,

RVL80, RVL90, RVL110,

RVL130, RVL150

Frequently Asked Questions

Q: How do I clean my FAN?

A: It’s important to clean the SHIELD cover from time to time. Dust particles can

build up on the SHIELD. See PAGE 19 for care and cleaning instructions.

Q: What is CFM?

A: CFM is a measurement of air movement (cubic feet per minute). The higher the

CFM, the more air movement.

Q: What is a sone?

A: Sone is the rating used to describe the sound level. The lower the sone the

quieter the fan. A sone is not a decibel. Fans around 1 sone or less are considered

quiet while fans around 2 sones or more are considered loud.

Q: Can I install my bathroom ventilation FAN directly over a bathtub or shower?

A: Yes, but your FAN must be rated for over a shower/bath installation (all ReVent

models are) and must be on a GFCI protected circuit. Consult a qualified licensed

electrician about ground fault protected safety circuits.

Q: Do I have to vent my FAN to the outside?

A: Yes. All spot ventilation fans must be vented to the outside. Follow your local

code and consult it for advice. See PAGE 6 for national venting installation

suggestions and guidelines.

Q: Why do the windows and mirrors fog even when the FAN is running?

A: If windows and mirrors are very cold, condensation can still form on those

surfaces. If the bathroom is sealed tightly, replacement air may not be entering the

room fast enough to displace moist air. You need a gap under the bathroom

entrance door to allow air to enter the bathroom. If your home uses 3 inch diameter

ducting, upgrading the duct pipe to 4 inch diameter can greatly increase the airflow.

The vent pipe length should be 10 feet or less with minimal bends (See PAGE 6).

Ensure that the vent pipe is not blocked.

Q: My FAN is operating, but the air is moving slower than normal.

A: Check for obstructions in the ductwork. A common problem is debris blocking the

roof cap or outside wall vent. Older homes may have 3 inch diameter ducting and

changing the duct pipe to 4 inch diameter can greatly increase airflow.

Q: Why is there water dripping from my FAN?

A: Dripping water is typically condensation from a cold vent pipe. Insulating the

ductwork and FAN housing can help solve condensation problems. Running the

FAN longer will ensure moisture is completely removed from the duct. Another

possibility is rain entering the vent pipe through the roof vent opening.

PAGE 1
models RVL50, RVL70, RVL80, RVL90, RVL110, RVL130, RVL150 Frequently Asked Questions Q: How do I clean my FAN? A: It’s important to clean the SHIELD cover from time to time. Dust particles can build up on the SHIELD. See PAGE 19 for care and cleaning instructions. Q: What is CFM? A: CFM is a measurement of air movement (cubic feet per minute). The higher the CFM, the more air movement. Q: What is a sone? A: Sone is the rating used to describe the sound level. The lower the sone the quieter the fan.
PAGE 2
Q: I have installed my FAN and it is not working, what do I do? A: Make sure the black and white plug-in connector on the FAN is clicked into place. Check all electrical connections like wire nuts and quick connects. Make sure the circuit breaker is turned ON after completing all the electrical work. If you have any concerns consult a licensed electrician.