CW-SR1000-3 Shoulder Support Rig Counterweight for SR-1000
Thank you for choosing Revo, and congratulations on your purchase of the Revo CW-SR1000-3 Counterweight for the SR-1000 Shoulder Support Rig. The Revo CW-SR1000-3 is a unique accessory for use with the SR-1000 Shoulder Support Rig. It adds a counterweight to the back of the Shoulder Support Rig that increases stability, relieves arm fatigue, and creates a more balanced system for easier maneuvering and handling of fully-loaded or front-heavy camera setups.
Attaching the CounterWeight to the SR-1000 Shoulder Support Rig 1 Align the screw holes in the narrow end of the angled mounting plate with the slot on the outside of the shoulder pad. 2 Attach the mounting plate by threading two of the included hex screws through the slot and into the screw holes. Use the included hex key to fasten the screws until fully tightened.
3 Align the counterweight’s screw holes with the corresponding screw holes on the outside of the mounting plate. 4 Attach the counterweight by threading the remaining two screws through the mounting plate and into the counterweight. Use the hex key to fasten the screws until fully tightened.
Important: The screws should go easily into the holes of the counterweight. If you feel resistance when turning the screws, turn the counterweight over and repeat the previous instruction. Specifications Weight: 3 lb. (1.4 kg) Length: 6” (15.3 cm) Width: 3” (8 cm) Height: 0.5” (1.
One-Year Limited Warranty This Revo product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later.
