Instruction manual

16 Channel Digital Video Recorder
45
Appendix
ERROR CODE NOTICES
SYSTEM UPGRADE RELATED BACKUP RELATED
No. Description No. Description
0
Unknown error.
0
Unknown error.
1
File version error.
1
Device error.
2
Operating system version error.
2
Mounting failed.
3
Software version error.
5
File already existed.
4
Kernel version error.
6
Not enough space.
100
Upgrade device mounting failed.
7
Creating temporary file failed.
101
Package is not found.
8
Opening disk failed.
102
Extracting package failed.
9
Formatting disk failed.
103
LILO failed.
10
Database has been changed.
104
Rebooting failed.
11
Appending failed.
105
Invalid package.
12
Bad sector.
300
Remote connection failed.
13
No executable file.
301
Remote network error.
14
Opening executable file failed.
302
Remote upgrade is not authorized.
15
Writing executable file failed.
303
Saving remote package failed.
16
Creating image failed.
304
Remote upgrade is cancelled by the user.
400
USB device mounting failed.
401
Reading upgrade package on the USB device failed.
402
Copying upgrade package on the USB device failed.
500
System is busy clip copying.
TROUBLESHOOTING
PROBLEM POSSIBLE SOLUTION
No Power
 Check power cord connections.
 Confirm that there is power at the outlet.
No Live Video
 Check camera video cable and connections.
 Check monitor video cable and connections.
 Confirm that the camera has power.
 Check camera lens settings.
DVR has stopped recording.
If hard disk drive is full, you will either need to delete video or set the DVR to the Recycle
On (Recycle When Disk Full) Mode. See Chapter 2 – Installation & Configuration,
Advanced Setup – Record Setup for details.
The icon displays, however,
the DVR is not recording.
When the DVR is in the Pre-Event recording mode, the yellow
and icons display
when there is no event, and the DVR is not recording. The red
and icons display
when any event occurs and the DVR starts recording.
IR remote control does not
work properly.
 Check the batteries in the remote control.
 Check that nothing blocks the infrared sensor on the DVR.
 Check the system ID setting for the remote control. See Chapter 2 – Installation &
Configuration, Advanced Setup – System Setup for details.
While upgrading the system, the
DVR keeps rebooting and the
upgrade fails.
If the current system version is higher than the upgrade package file version, you should
reset the DVR first using the Factory Reset. When using the Factory Reset, you will lose
any settings you have saved.