Use and Care Manual

User’s Manual

You will be able to check the model name, serial number and the time information

about recorded data of the selected storage device.

If you want to erase recorded data on the selected device, highlight Clear and

press the

button. You will be asked whether or not you want to delete the data.

System Event

Figure 12: System – System Event setup screen.

The DVR can be configured to run self-diagnostics and report the results.

Highlight the Settings box beside the desired event (System, Check Recording, Check Alarm-In, Disk Almost

Full, Disk Bad, or Disk Temperature), and press the

button.

Highlight the Settings box beside System and press the button. You can select the interval that you want the

DVR to run self-diagnostics on the system. You can select from 1 hr. to 30 days or Never.

Highlight the Settings box beside Check Recording and press the button. The Check Recording screen appears.

Highlighting Schedule On and pressing the button toggles On

and Off. When set to On, you can select the day, time range and

interval that you want the DVR to run self-diagnostics on the

recorder. The Interval can be selectable from 1 min. to 7 days or

Never. Highlight the + and press the

button to add a schedule

item. The

box allows you to delete a check recording schedule.