Use and Care Manual

Digital Video Recorder
29
When the DVR is in the No Record mode, it will not record during the preset day and time range as long as the
PANIC
button is not pressed. Use the No Record mode when you do NOT want the DVR to record during certain times.
When the DVR is in the Time
mode
, the icon displays at the top-left corner of the screen. The DVR will record
and displays the
icon at the top-left corner of the screen during the scheduled times.
When the DVR is in the Event mode, the red icon displays at the top-left corner of the screen. The DVR will
record and displays the
icon at the top-left corner of the screen when any event occurs. When the DVR is in the
Pre-Event recoding mode, the yellow
icon displays when there is no event, and the DVR is not recording. When
the DVR is in the Pre-Event mode, the red
and display when any event occurs and the DVR starts recoding.
When the DVR is in the Time & Event mode, the DVR will follow the Time settings and the icon displays at the
top-left corner of the screen. The DVR follows the Event settings and the
icon displays.
Highlight the box under the Channels heading and press the
button to select which cameras will be recorded.
(Simple Mode Only)
Highlight the box under the Settings heading and press the
button to define the recording settings.
Figure 15: Schedule – Settings (Advanced Mode) setup screen.
You can set the ips, Quality and Resolution (ips, Quality, Resolution and Dwell for Advanced Mode setup) of the
recording for any modes you set up in the Mode column. If you do not set the ips, Quality, Resolution and Dwell in
the Settings column, the DVR will follow the default settings. See below for details.
NOTE: Descriptions of the Record icons in the Type column are as follows:
Time-lapse (Time) Alarm-In Motion
Video Loss Video Blind Text-In
Channels that are not defined will use the setting values of the previous schedule item.
When multiple events are detected at the same time from a specific channel, the DVR will record event
video with the high setting values if the ips, Quality, Resolution and Dwell values of events are different
from each other. However, the ips will be reset to the supported maximum value when the ips, Quality,
Resolution and Dwell are all set to the highest value. (Advanced Mode Only)
Highlight the box under the heading and press the
button to delete the recording settings. You will be asked to
confirm that you want to delete the settings.
Highlight Default… and press the
button. The Default screen appears.