Use and Care Manual

Digital Video Recorder

Event Setup

Motion

Figure 17: Event – Motion setup screen.

Your DVR has built-in video motion detection. Video motion detection can be turned On or Off for each camera.

Highlighting the box under the Sensitivity heading and pressing the

button

allows you to adjust the DVR’s sensitivity to motion for Daytime and

Nighttime independently. There are five settings with 1 being the least

sensitive and 5 being the most sensitive.

You can define the area of the image where you want to detect motion; e.g., a doorway. Highlight the box under the

Zone heading, and press the

button. The Motion Zone screen displays.

The Motion Zone screen is laid over the video for the selected camera.

You can set up motion zones by selecting or clearing blocks.

NOTE: You can set up motion zones one block at a time in groups

of 16 individual block groups. A

block group is positioned within the image area using the Up and

Down arrow buttons, and individual blocks within the block

groups are selected or cleared using the camera buttons.

Press the button to display the menu screen. The menu on the setup screen has the following functions:

Select – Activates highlighted blocks to detect motion.

Clear – Deactivates highlighted blocks so that they will not detect motion.

Reverse – Activates inactive highlighted blocks and deactivates active highlighted blocks.

Select All – Activates all blocks to detect motion.

Clear All – Deactivates all blocks so that they will not detect motion.

Reverse All – Activates inactive blocks and deactivates active blocks.

Zone View – Displays any detected motion within the zone in red.

OK – Accepts changes and closes Zone setup.

Cancel – Exits Zone setup without saving changes.