Use and Care Manual

Digital Video Recorder

Highlight the box beside Type and press the

button. You can select the type of network configuration from:

Manual, DHCP and ADSL (with PPPoE). Select the desired type and press the

button.

Selecting Manual from the Type allows you to set up LAN parameters manually.

Change the numbers by highlighting them and using the Up and Down arrow buttons to increase or decrease the

number. The factory default LAN settings are:

IP Address: 192.168.1.129

Gateway: 192.168.1.254

Subnet Mask: 255.255.255.0

NOTE: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network

administrator.

Highlight the box beside DNS Server. Press the Up and Down arrow buttons to set the IP address of the DNS server.

Highlight the Port Number Setup… box and press the button. The Port Number Setup screen appears.

NOTE: You will need to get the appropriate Port Numbers for each REVO Remote Pro and REVO Remote

related program (Admin, Callback, Watch and Search) from your network administrator.

Change the numbers by highlighting them and using the Up and

Down arrow buttons to increase or decrease the number. The factory

default Port settings are:

Remote Admin: 8200

Remote Callback: 8201

Remote Watch: 8016

Remote Search: 10019

NOTE: The system restarts automatically after changing the port settings.

Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected

with the PC running REVO Remote Pro or REVO Remote.

CAUTION: When changing the port settings, you must change the port settings on the PC running

REVO Remote Pro as well. Refer to the REVO Remote Pro manual for details.

Highlight Use UPnP and press the

button to toggle between On and Off. When it is On, port forwarding from

the NAT (Network Address Translation) device to the DVR will be enabled automatically via UPnP (Universal Plug

and Play) service. This function will be especially useful when accessing a port on a private IP address.

NOTE: For the UPnP service to work, the NAT device should support the UPnP Port Forwarding function and

the function should be set to enabled.

You cannot change the port settings when Use UPnP is On.

Highlight the Status box and press the button to display the port numbers forwarded from the NAT device via

UPnP service.

Highlight the Test box and press the button to test the current LAN settings you made.