Use and Care Manual

User’s Manual
54
Display
 Full Screen: Selecting
(Display) →
(Full Screen) and choosing the camera number button displays the
selected camera full screen. It is the same as pressing the individual camera buttons on the remote control or
clicking the left mouse button on a camera image when in one of the multiview formats (i.e., 2x2, 1+5, 1+7, 3x3 or
4x4). Clicking the left mouse button on the screen again returns to the previous display mode.
 PIP, 2x2, 1+5, 1+7, 3x3, 4x4: Selecting
(Display) →
, , , , or (PIP, 2x2, 1+5, 1+7, 3x3 or
4x4) displays the cameras in the selected multiview screen mode (PIP, 2x2, 1+5, 1+7, 3x3 or 4x4). Selecting each
display mode is the same as pressing the
LAYOUT button or scrolling the mouse wheel up and down when in one
of the multiview formats (i.e., 2x2, 1+5, 1+7, 3x3 or 4x4).
NOTE: In the 1+5 or 1+7 display mode, the main channel indicates the channel displayed on the large screen
which is displayed in the top-left. You can select the camera you want to display on the main channel
screen. Select a channel on the screen and click the right mouse button to display the Camera Menu.
Selecting Go To Main swaps the selected channel with the main channel. This function is supported
only in the 1+5 and 1+7 display modes and can be activated from any of channel screens except the
main channel screen.
 Camera OSD, Status OSD: Selecting
(Display) → Camera OSD or Status OSD toggles Camera OSD
or Status OSD On and Off.
Previous Group, Next Group
Selecting
or (Previous Group or Next Group) in the Live Monitoring menu moves to the previous or next page.
It is the same as pressing the Left or Right buttons on the remote control.
Freeze
Selecting
(Freeze) in the Live Monitoring menu will freeze the current image on the screen until you select
again. Pressing any button except for the
MENU and PANIC buttons while in the Freeze mode can also exit the Freeze
mode. While in the Freeze mode, the icon displays in bottom-left corner if Freeze is selected in the Display setup
screen (OSD tab).
Alarm
Selecting (Alarm) in the Live Monitoring menu resets the DVR’s outputs including the internal buzzer during an
alarm. It is the same as pressing the ALARM button.
Panic
Selecting (Panic) in the Live Monitoring menu starts panic recording of all cameras, and selecting again stops
panic recording. It is the same as pressing the PANIC button.
Sequence
Selecting
(Sequence) in the Live Monitoring menu causes the cameras to display sequentially. It is the same as
pressing the
SEQUENCE button. When in one of the multi-view formats, selecting will cause the DVR to go
through predefined screen layouts (Full Sequence). Or, the bottom, right screen will display live cameras sequentially
(Cameo Sequence). For example, if you select in the 2x2 format, the DVR changes pages as follows:
< Full Sequence >
< Cameo Sequence >