User Manual

- 12 -
Transmit Power
The transmit power of the Base Station can be adjusted to help reduce the operational radius of a
Executive HD System in order to prevent interference from other Revolabs Products, or from other
devices operating in the same frequency. The options for transmit power are ‗0-7‘ with ‗0‘
representing the lowest power and ‗7‘ representing the highest power. This configuration setting can
also be controlled using the Base Station front panel display.
Note: It is recommended that the lowest functioning Transmit Power be used for each system.
Box Address
Each Executive HD Base Station must be assigned a unique Box Address when multiple Base
Stations are connected with a BUS cable. The options for Box Address are ‗0-7‘ with ‗0‘ being the
default.
Note: The Master Mute function will not propagate to the entire HD system if each connected Base
Station does not have its own Box Address.
Lock Front Panel Display
The Front Panel display can be locked to keep the front panel controls from changing any
configuration settings. The ‗Lock Front Panel‘ mode can be activated by selecting the option in the
‗config‘ tab of the device window.
Base Station Operation Mode
This displays the current state of DIP switch #1 located on the rear panel of the Base Station. It will
display either ‗Primary‘ or ‗Secondary‘ mode.
Status Monitoring:
The Revolabs HD Control Panel monitors the Executive HD Base Station and Microphones. All status
monitoring is located in the ‗Monitor‘ tab of the device window.