User Manual

- 13 -
Microphone Type
This provides the current type for the microphone that is active on each channel.
Microphone Status
This provides the current status for the microphone paired to each channel.
Microphone Version
This provides the current firmware version for the microphone that is active on each channel.
Microphone Battery
This provides the current battery level for the microphone that is active on each channel.
Versions
This window provides all the current firmware versions found in the Base Station.
Status
This window provides any activity status between the HD Control Panel and either the Base Station,
or the Charger Base.
Using the Serial Control Processor (RS-232 or IP)
The Serial Control Processor allows the use of a third party control system or DSP to monitor and
control the Executive HD Base Station and Microphones. The Executive HD Base Station must be
configured for the correct ―Serial Control Processor‖ using the Revolabs Audio Control Panel
software.
Using the Executive HD Base Station with a Control System
The Executive HD Base Station is capable of being monitored and controlled via any serial capable
control system. The only logic communication that takes place between multiple Base Stations, via
the ‗BUS‘ cable, is ―Master Mute‖ status. Therefore, each Base Station requires its own serial
connection to the control system in order to communicate. The ―Control System‖ option must be
selected, under the ―External Control Processor‖ drop down menu in the Executive HD Control Panel
program, in order for this configuration to function properly. You must also set the RS-232 or Network
settings of the Base Station to match the communication settings of the control system.