User Manual

- 27 -
1. Connect to the Base Station(s) as described in Using the Revolabs HD Control Panel
Software Interface.
2. Select ‗Update Firmware‘ in the firmware menu.
3. Select the desired firmware version from the menu in the pop-up window.
4. Select the Base Station(s) that you would like to update.
5. Select OK and watch the firmware process either on the Base Station front panel display or
in the ‗monitor‘ tab in the Revolabs HD Control Panel program. The HD Control Panel will
notify you when the process is complete.
Note: You cannot update a „Primary‟ and „Secondary‟ Base Station at the same time. Only Base
Stations set to the same mode can be updated collectively.
Updating the HD Microphones
The HD Microphone firmware can be changed using the Revolabs HD Control Panel program and the
HD Charger Base. Communication to the Charger Base is done over a mini-USB connection.
1. Connect the Mini-USB cable from the back of the Charger Base to your PC.
2. Place all microphones in the Charger Base and wait for a solid GREEN or RED LED on
each microphone.
3. Start the Revolabs HD Control Panel.
4. Select ‗Update Mics‘ from the ‗Charger Base‘ menu.
5. Select the desired firmware version from the menu in the pop-up window.
6. Select OK. All mics will turn off and you will start seeing RED LED activity on the Charger
Base. Wait for all mics to update and the Charger Base LED indicator to return to solid
GREEN.