User's Manual

40
Reset Defaults
1. Go to Menu Setup  Advanced Setup 
Admin Settings  Reset Defaults.
2. Resetting defaults will revert back to factory
defaults. Pairing of devices, recent calls, the
contacts, and the system name are not affected
by this.
Set Password
1. Browse to the Set Password menu: Menu 
Setup  Advanced Setup Admin Settings Set
Password.
2. Set the password to an admin specified password.
Note that setting this password will override the
default password, so do not lose the new
password.
Log Out Admin
1. Browse to Log Out Admin: Menu  Setup 
Advanced Setup Admin Settings Log Out
Admin.
2. Once logged out, the user will have to retype the
admin password to enter the administrative menus
again. If the user leaves the administrative menus
without logging out, an automatic log-out will
happen after about 15 minutes.
Pairing
All FLX2 wireless components are paired before the system is shipped, providing much
of the system setup already completed. While pairing should not be required for the
system to work, sometimes components can require pairing if a part is shipped
separately.
The following are instructions on how to pair the wireless components of the system to
the FLX2 Conference Phone. All components are paired to the Base, which is the
central unit that communicates with all other components. To pair a Microphone or a
Speaker to the FLX Conference Phone, a FLX Dialer has to be paired first. If several
components need to be paired, or a whole system neds to be paired, start with the FLX
Dialer.
Dialer
1. Turn off the Dialer by pressing and holding the red ‘end call’ button until an
overlay appears asking whether you want to shut the Dialer down. Press ‘Yes’.
2. Plug in the FLX2 Base Station.
3. Turn the Dialer back on (press the red ‘end call’ key). The screen should read
“Scanning for new base”. If the screen reads “scanning for paired base”, press