Manualshelf

User's Manual

ManualsBrandsRevolabs ManualsElectronicsFLX MICROPHONE CONTAINING DECT TRANSCEIVER OF THE FLX CONFERENCE PHONE SYSTEM
41424344454647484950
41
the ‘Stop’ button, press the ‘Menu’, and select ‘Re-Pair’. When asked whether to
‘Scan for New Base’, select ‘Yes’.
4. After some time scanning for available bases, an overlay will appear asking ‘Pair
with <System Name>?’ The system name is either the Factory preset name of
FLX_xxxxxx, with xxxxxx the last 6 digits of the BT number on the bottom of the
Base station, or the system name you previously selected in the Advanced
Setup. Select ‘Yes’.
5. An overlay, ’Pairing with base <System Name>’, should appear followed by a
‘Connecting…’ and then and ‘Initializing…’ screen. Shortly after that the Dialer
home screen will appear. Your Dialer is now paired.
6. If the Dialer does not automatically pair, repeat steps 1-5. If this still does not
resolve the problem, select “Reset Factory Defaults” as this will force a scan for a
new base.
Speaker
1. To pair a Speaker first turn it off by pressing and
holding the button on the bottom of the Speaker until
you hear the Speaker shut-off or the LEDs turn off.
2. Ensure that the Base Station is plugged in and powered
up.
3. On the Dialer, browse to the Pairing menu: Menu
Setup Advanced Setup Pairing.
4. Select SPK 1 (Speaker 1) and press the ‘Enter’ or ‘Pair’
key to enter pairing state.
5. The screen will display ‘Pairing Speaker 1’.
6. Press and hold the button on the bottom of the Speaker
until the LED turns solid red. The speaker is now in
pairing mode.
7. After a short time an overlay will appear on the FLX
Dialer saying ‘Pairing Successful’, after that the screen
should read ‘SPK 1 Linked’.
8. If pairing was unsuccessful, the Speaker will show an
alternating red -green slow blinking sequence indicating
that the pairing failed. The Dialer will display a ‘Pairing
Timeout’ message. In that case the pairing procedure
should be repeated.
Microphone
1. To pair a Microphone, turn off the Microphone by holding the mute button until
the LED turns red if it is not already turned off.
2. Ensure that the Base Station is plugged in and powered up.
3. On the Dialer, browse to the Pairing menu: Menu Setup Advanced Setup
Pairing.
4. Select MIC 1 (Microphone 1) or MIC 2 (Microphone 2) and press the ‘Enter’ key
to enter pairing state.
5. The screen will display ‘Pairing Mic 1’ or ‘Pairing Mic 2’ depending on which
Microphone you are pairing.