User's Manual

6. Press the mute button on the Microphone and hold it until the LED turns solid

red. The Microphone is now in pairing mode.

7. After a short time an overlay will appear on the Dialer ‘Pairing Successful’, after

that the screen should read ‘MIC 1 Linked’ or ‘MIC 2 Linked’, based on which one

you were linking.

9. If pairing was unsuccessful, the Microphone will show an alternating red - green

slow blink sequence, indicating that the pairing failed. The Dialer will display a

‘Pairing Timeout’ message. In that case the pairing procedure should be

repeated.

LED Pairing Indicators:

Speaker Indicator

Status

Steady Red Speaker is in Pairing Mode, either waiting or pairing in progress

Slow red- green flash Pairing failed or timed out

Green flash Pairing successful

Microphone Indicator Status

Steady Red Pairing Mode, either waiting or pairing in progress

Slow red – green flash Pairing failed or timed out

Green flash Pairing successful

Phone Settings

1. Browse to the Phone Settings menu: Menu 

Setup  Advanced Setup  Phone Settings.

a. You can change the dialing method by

selecting the entry, and then pressing the

‘Select’ key. The factory preset is TONE.

b. You can set the telephone number of the

FLX2 System using the Phone Number

setting. Select this entry, type in the

number, and press ‘Enter’ to capture the

telephone number.

c. Selecting Hook Flash Time you can change

the time for a hook flash to be sent to your

network. Factory default is 75 ms, you can

increase this by selecting another entry in

the menu.

d. Disconnect ON/OFF allows you to ignore

signals sent by the far side indicating a

hang-up. If you are seeing ‘Line in Use’

messages on your phone even though the

line is not in use, this setting has to be set

to OFF.