user manual

Revolabs Single Channel System - Polycom HDX 9004 Setup Guide

NOTES AND CA UTIONS:

This setup guide will guide you through the steps needed to properly connect a

Revolabs Single Channel System to a Polycom HDX 9004 video codec.

1. Connecting the Cables

2. Configuring the HDX 9004 Video Codec

Note:

It is important to carefully follow these instructions in order and completely .

Otherwise your Single Channel System and/or the video codec may not function

properly. Please read through these instructions completely before proceeding.

Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Single Channel System

2. Revolabs 2.5mm to RCA Audio Cable (included with Single Channel)

3. Polycom HDX 9004 video codec

4. Polycom Audio Adapter Cable (P/N 2457-23492-001) or equivalent*

*POLYCOM HDX 9000 SERIES VIDEO CODECS HAVE PHOENIX CONNECTO RS FOR AUDIO INPUT/OUTPUT WHILE REVOLABS

SINGLE CHANNEL SYSTEM PRODUCTS USE RCA CONNECTORS FOR AUDIO INPUT/OUTPUT. THE POLYCOM AUDIO ADAPTER

CABLE CONVERTS TWO PHOENIX CONNECTORS INTO FEMALE RCA CONNECTORS. OTHERWISE, A TECHNIC IAN COULD SIMPLY

CUT OFF THE ENDS OF THE RCA CABLES AND CONNECT PER THE DIA GRA M ON THE FOLLOWING PA GE:

PAGE 1
Revolabs Single Channel System - Polycom HDX 9004 Setup Guide NOTES A ND CA UTIONS: This setup guide will guide you through the steps needed to properly connect a Revolabs Single Channel System to a Polycom HDX 9004 video codec. 1. Connecting the Cables 2. Configuring the HDX 9004 Video Codec Note: It is important to carefully follow these instructions in order and completely . Otherwise your Single Channel System and/or the video codec may not function properly.
PAGE 2
PAGE 3
Connecting the Cables CONNECTING A REVOLA BS SINGLE CHA NNEL SYSTEM TO POLYCOM HDX 9004 VIDEO CODEC 1. Connect a Revolabs 2.5mm to RCA audio cable between the 2.5mm analog output on the Single Channel System and the red “Audio Input 1” port on the HDX 9004.
PAGE 4
Configuring the HDX 9004 Video Codec CONFIGURI NG THE A UDIO MENUS OF THE HDX 9004 VIDEO CODEC 1. 2. 3. 4. 5. 6. 7. 8. 9. Select SYSTEM Select ADMIN SETTINGS and enter the Administrator password (if needed) Select AUDIO Select AUDIO SETTINGS Disable POLYCOM MICROPHONES by removing the check mark. Having Revolabs and Polycom microphones will increase ambient noise, add to echo cancellation problems, and reduce articulation* Verify LIVE MUSIC MODE is disabled by removing the check mark.