user manual

ManualsBrandsRevolabs ManualsTelephoneInc. Telephone uc500

Technical Note

1 | Page

FLX – VoIP Registering with Cisco UC500/CME Series

Date: March 13

, 2012

This technical note gives a detailed description on how to register a Revolabs FLX conference phone with

a Cisco UC 500/CME series. On the UC 500/CME series a SIP extension and user has to be created using

the Command Line Interface (CLI). Once that user is created, the FLX can be set up to register with the

UC500/CME series PBX.

To perform the tasks described in this document, the user needs to have administrative rights on the

Cisco UC500/CME. While the steps in this document are not difficult, we recommend that a trained

Cisco administrator should perform them.

The instructions provided here were collected using a Cisco UC560. Other versions of the Cisco

UC500/CME series may differ, though the general procedures are the same.

Configuring Cisco UC500 series PBX for FLX Registration

The configuration of SIP devices on the UC500/CME series is straightforward. The SIP CME feature in IOS

is used to register the FLX as a generic SIP endpoint.

The following IOS CLI commands are needed on the UC500/CME device. Please note that in your setup

the dn numbers and the pool might be different based on other SIP devices you have installed.

Summary of content (5 pages)

PAGE 1
Technical Note FLX – VoIP Registering with Cisco UC500/CME Series Date: March 13th, 2012 This technical note gives a detailed description on how to register a Revolabs FLX conference phone with a Cisco UC 500/CME series. On the UC 500/CME series a SIP extension and user has to be created using the Command Line Interface (CLI). Once that user is created, the FLX can be set up to register with the UC500/CME series PBX.
PAGE 2
FLX & Cisco UC500/CME Technical Note voice register global mode cme source-address 10.1.1.1 port 5060 ----- IP used for SIP Registrar/Proxy max-dn 1 max-pool 1 ! voice register dn 1 number 700 ----- Directory Number Assigned to the FLX no-reg ! voice register pool 1 id mac 0020.F735.
PAGE 3
FLX & Cisco UC500/CME Technical Note Registering the FLX with the Cisco UC500/CME You can use either the FLX handset or the FLX web UI to register the FLX with the Cisco UC500/CME. We are showing how to do it with the web interface. 1. IP address of the FLX. a. If you are using DHCP in your environment, the FLX automatically receives an IP address. From the FLX handset, choose Menu and “System Info” (the symbol with the “i”) and select “About System”.
PAGE 4
FLX & Cisco UC500/CME Technical Note Username – enter the same User ID as above Password – the End User’s password, in our example ext700 5. Press “Save”. You will see the following screen. 6. On the left, select “SIP Configuration”.
PAGE 5
FLX & Cisco UC500/CME Technical Note 7. For the DTMF Signaling method select “SIP INFO”. 8. Press “Save”. 9. On the left side select “Restart”, and click on the “Restart” button. Your FLX phone will restart. You can close the Web browser. If registration is successful, the handset will show the user ID at the top of the home screen. If there is a registration failure, the handset will show that the phone is not registered.