Product specifications

If a microphone is lifted from the Charger Base and the LEDs continuously flash alternating RED

and GREEN, and/or the Base Station LED flashes alternating RED and GREEN, the microphone

needs to be paired to the system. Make sure that all other microphones are properly paired, and

that the Base Station is powered on, before proceeding to pair an individual microphone. By

noting which microphone channels are already in use (paired), it will be obvious which channel to

use for pairing the microphone.

Microphone Pairing Instructions

1. First make sure the microphone is turned OFF (no LED activity). If the unit is ON, press and

hold the MUTE button for 10 seconds until the LED turns solid RED (do not release when you

hear two beeps). Release the button to turn the unit off.

2. Next, place the microphone unit into pairing mode by holding the MUTE button down for seven

seconds. The LED will turn solid GREEN and then solid RED. Release the MUTE button. The

microphone unit is now in pairing mode.

3. Within one minute, push and hold the button for the desired channel on the Base Station for

seven seconds to enter into pairing mode. The LED for that channel will be solid RED until

pairing starts, as indicated by Solid RED followed by a quick GREEN flash, then switching to

flashing RED on both the microphone and the Base Station (muted audio). Pairing is now

complete.

Pairing Charger Base to Base Station

“Pairing” is also used to create a link between the Charger Base system MUTE control and the

Base Station. When the Charger Base and Base Station are paired, the system mute function

may be used.

The Charger Base in new systems come paired to the Base Station. However, if a replacement

Charger Base is ever required, it will need to be manually “paired.”

System Mute Button Pairing Instructions

1. First, power-on the Charger Base and Base Station (power LEDs on both units are GREEN).

2. Next, place the Base Station system into pairing mode by briefly pressing the LEARN button on

the rear connection panel. The pairing LED next to the LEARN button will illuminate.

3. Now press the MUTE button on the Charger Base once. The pairing LED on the back of the

Base Station panel will go off and the power LED on the Charger Base will turn solid RED.

4. Press the MUTE button on the Charger Base again. The pairing LED on the Base Station will

flash twice and the power LED on the Charger Base will turn solid GREEN.

5. Once the pairing LED on the Base Station stops flashing, pairing is complete and the MUTE

button on the Charger Base will mute all the microphones in the system.