REVLC06S40A-SPA-MC Revolectrix PowerLab 6 Manual

29
13. PowerLab 6 is ready to charge another battery (step 3).
Start faster
When following the instructions above, you probably noticed that PowerLab 6 asks a lot
of questions before it starts a charge, discharge, cycle or monitor. That enables you to
specify exactly what operations PowerLab 6 will perform. If all you want to do is Charge
a battery, and once you have a preset configured properly, two settings in the CCS
Options tab will speed up the process:
Activate the Enable Quick Start option.
When activated, Enable Quick Start lets you bypass many of the questions needed to
start a process. After activating this feature, press and hold ENTER if you don’t want to
select options such as charge/discharge rate, discharge/cycle/monitor.
Disable the Choose Power Source at Startup option (only if you consistently use the
same power source).
On startup, PowerLab 6 will always use either the DC Power Supply or Battery profile—
whichever was last loaded before disabling the prompt.