Installation Manual

Insert the

tailpiece into

the center

hole

Route the cable connected on the exterior assembly under the deadbolt. Align the tailpiece

with center hole of the deadbolt, and insert it into the center hole. Place the supplied adhesive

strip to hold the keyed side of the lock in place.

INSTALLING EXTERIOR ASSEMBLY

To install the exterior assembly:

2.1

2.2

•

If the diameter of your cross bore is 2⅛”(54mm), install directly.

If you have a 1½”(38mm) crossbore, remove the spacer.

Measure your cross bore dimension and determine the installation

steps accordingly.

STEP 2

IMPORTANT:Before installation, make sure the latch is fully retracted (in the unlocked position).

IMPORTANT:

Make sure the rubber gasket is on the exterior assembly before

installation, otherwise the exterior assembly will not be waterproof.

(optional)