Product Manual

9
1 INTRODUCTION
Storage Mode
Storage mode is designed to charge the house battery to its optimal level and maintain
that level while your caravan is in storage. This mode requires all loads to be switched
off or disconnected from the house battery before charging. It uses a 8-stage* charging
profile consisting of Desulphation*, Soft Start, Boost, Absorption, Battery Test, Equalise**,
Float and Maintenance stages (see Figure 1.5.2). Storage mode is designed to detect a
wide range of battery fault conditions. For more information on these fault conditions,
please refer to the Troubleshooting section of this manual.
Unlike Touring mode, Storage mode does not continue to cycle through charge profiles.
This means that when the charging process is completed, The Manager30 in Storage
mode will always remain in either Float or Maintenance stages. Float stage provides the
house battery with a ‘trickle’ charge whenever the house battery voltage drops below a
predetermined threshold to ensure the battery stays charged. Maintenance stage turns
The Manager30 output off, but continues to monitor the house battery and will revert to
Float stage when necessary.
NOTE: If The Manager30 is set to Storage mode and the vehicle is started The
Manager30 will automatically switch to Touring mode once it senses an increase in
input voltage from the alternator.
When using the charger in Storage mode, make sure that there is a valid charging
source and that all loads are disconnected from the house battery. Failure to do so
may cause the house battery to be under charged, give false readings on the State
of Charge indicator and possibly cause damage to any loads connected.
*The Lithium profile does NOT incorporate a Desulphation stage.
**The Lithium, AGM and Gel profiles do NOT incorporate an Equalise stage
BATTERY TEST
FLOAT
SOFT START
DESULPHATION
Desulphation*
Current
Storage Mode Charging Process
BOOST
ABSORPTION
MAINTENANCE
EQUALISE
MaintenanceFloatEqualise**AbsorptionBoostSoft Start Batt. Test
Voltage SLA
Voltage Lithium
Figure 1.5.2 - Storage Mode Charging Process