User Manual

The propellers on the Vizo drone are marked near the

center with an “A” or “B.” If a propeller is ever damaged

and needs to be replaced, always replace the propeller

with the same letter type.

CAUTION: Always disconnect the battery before

performing propeller maintenance.

1. Remove the screw from the top of the propeller and

remove the propeller by pulling straight up.

2. Using the illustration as a placement guide, replace the

propeller. Make sure to line up the screw hole in the top of

the motor with the corresponding hole in the propeller.

B A

A B

Installing the Smart Device Mount

1. Remove the faux antenna by pulling it straight out.

2. Insert the smart device mount into the faux antenna

plug. Use the right-hand screw to adjust the mount

angle.

3. Secure the smart device to the transmitter by tightening

the rear screw.

Using the Vizo View App

The Vizo View app is free software for your 2.4GHz WiFi-

capable smart device allowing you to:

• connect to the Vizo View camera as FPV

• take videos and pictures

• control the Vizo drone using a smart device

1. Install the Vizo View app from Google Play or the App

Store.

2. Install a micro memory card.

3. Connect a fully charged Li-Po battery.

NOTICE: When using a smart device to ﬂy FPV, expect

latiency between the smart device and the drone. Keep

your drone within visual range.

NOTICE: The transmitter must stay powered off to

completely control your drone via the Vizo View App.

The Vizo View on-screen control sticks are disabled

when connected to your transmitter.

Replacing the Propellers