Technical data

M203 EIB/ KNX
Re:connect
9
Setup key
Using the Setup key, you can
call the M203 menu, which
appears in the M51 display.
Using the Softkeys
you can get to pages #1 and #2
Slot Selection
If a second M203 (M200) is
connected to the M51 Link
output, a different address must
be assigned through the slot
selection so that both M203s don’t
occupy the same slot address.
This would cause errors. In the
case of a double assignment,
neither of the two M203s would be
shown in the M51 Version list.
Slot addresse: #11 or #12
Important:
Only one M203 may be connec-
ted to the M51 Link for the
address selection. You should
separate the one M203 from the
M51 Link while assigning the
address to the other. If the
addresses are correctly set, both
M203s (M200) will appear in the
M51 version list.
You will find further information
on this topic in the M51 manual
in the Introduction chapter
under the Version function.