Technical data

M203 EIB/ KNX
Re:connect
11
Important information
• Parallel operation
The Revox M217 Wall-
mounted display and/or the
M218 wall-mounted control
panel can be installed
parallel to an EIB Controller.
Both controllers have the
same priority. The M217
wall-mounted display
modifies the address within
a zone.
• Wall-mounted display
retrofit
Retrofitted M217 wall-
mounted displays modify the
addresses within a zone. In
this case, you should check
the addresses of the
Additional room amplifiers
and if necessary, adjust the
EIB addresses to the new
constellation.
• IR controller in the rooms
If you want to have
Multiroom control through a
Revox remote control as well
as through the EIB keypad
units, an “invisible” IR control
can be achieved using the
small M204 IR receiver.
The IR receiver is connected
directly to the M219 Additional
room amplifier and controls the
devices within the Revox
system.
The M204 is available in four
different models.
Setp #2 – EIB Debugger
There is an information window in
the middle of page #2, which
gives an overview of the activity
on the EIB data interface.
The following activities are
logged:
Resend
The number of repetitions when
the EIB data interface doesn’t
respond to a telegram the first
time.
Acknowledge
The number of confirmations sent
to the EIB data interface.
Init
The number of BCU initiali-
sations. As a rule, only one
initialisation is carried out after
commissioning.
Receiver
The number of received EIB
protocols.
Transmit
The number of EIB protocols sent
to the EIB data interface.