Technical data

M203 EIB/ KNX
Re:connect
3
M203 EIB-Bridge
The M203 EIB-Bridge establishes
the bridge between on the one
side the Revox Multiroom System
and on the other side, the EIB
Domestic facility management
system.
The data exchange occurs
between the M203 EIB serial
interface and a serial EIB data
interface for bus couplers.
Installation
The M203 interface can be
installed easily and quickly.
There are two types of fixing
available.
Connection plan
The M203 EIB-Bridge is only
designed to handle communi-
cation with an EIB data interface
and cannot receive any other
protocols. The normal RS232
software (203-1) can be loaded
using the Revox programmer.
The EIB software is not copy
protected.
1) The four outside fixing holes
are used for a permanent
installation.
2) Revox recommends using
the two slots on the side for a
variable installation.
Serial interface activity display
Slotted hole
Connection to the M51
Connection to further external M51-Interfaces
RS232 seriell interface
IR-/ wall-mounted remote control M204/ M218
Setup button