Technical data

M217
8
1 2 3 4 5 6
Installation procedure
You should avoid applying
any pressure to the display
during or after installation.
1) Install the mounting fixture (5)
with the fixing plate (4) onto the
recessed box or the surface
mounted box on the wall.
2) Strip the insulation off the U72
installation cable and feed it
through the mouting fixture (5).
3) Connect the cable to the
screwed terminal block.
4) Connect the terminal block with
the print connector on the back
of the operator panel (1).
5) Locate the operator panel (1)
with its frame (3) onto the
mounting fixture (5), so that the
locating springs (2) on the panel
(1) line up with the slots in the
mounting fixture.
6) Press the operator panel (1)
onto the mounting fixture (5)
until the springs clip into place.