Technical data

Re:control M217
13
M217 Address setting
Connection to a Re:system device (M10, M100, M51)
If the M217 is connected directly to a Re:system device (M-Link) the address
setting is not significant. The M217 will be recognises automatically.
Connection to the M219 side room amplifier
If, on the other hand, the M217 is to be connected to a M219 side room amplifier,
address setting is very important. The M217 address defines which M219 should
be communicated with. In this way, the M217 address is set through DIL
switches 3 & 4, based on the M219’s address.
Use the free-of-charge Multiroom Planner 2.00 software from Revox for the
addressing. You will find more about this under www.revox.com.
The M218 keypad is not taken into account during addressing as it has no own
address. The M218 keypad can always be connected to a M219 Additional room
amplifier or a M217 display.
Example: If the M219 has address 2, address 2 must also be set at the M217
Display.
Address
DIL switch
3
DIL switch
4
DIL position
1 Off Off
43
2 Off On
43
3 On Off
43
4 On On
43
Within in one zone, all M217s must have different addresses as otherwise there
can be communication problems. The maximum number of M217 in any one zone
is restricted to 4.
The revisal of a correct addressing is made in the Setup menu of the Re:system
device, category
Multiroom / Version . All attached devices (M219 and/or M217)
must be listed in the respective zone.