Technical data

Operation M217
24
Nested events
Through the Timer programming, you
can create nested events. Nested
events occur when two different
events address the same source and
at the same time.
In our example, Event 1 and Event 2
have a time overlap. Since they both
address the same source, Event 1
defines the switch-on point while
Event 2 defines the switch-off time.
L
In the case of nested events then, the
event that occurs at an earlier
timepoint defines the switch-on
and/or switch-off timepoints.
Sleep function
Using the Sleep function, you can
define a length of time after which
the Re:system device or the M219 will
automatically switch off.
By repeatedly pressing the Sleep
softkey, you can step through a loop
in 15 minute steps, to set the required
time period. The loop starts with 90
minutes and ends with switching the
Sleep function off.
The current Sleep time setting is
shown in the top line of the display.
Sleep
Event 2
Event 1
ON
ON
OFF
Active time
OFF
90‘
75‘
60‘
45‘
30‘
15‘
OFF s