Technical data

Re:control M217
3
Danger warning
Improper mounting of this device in
an environment with low-voltage
products (230 V AC) can cause
serious health problems or damage
to property. This product is intended
for connection to extra low voltage
circuits and may never be connected
to low voltage (230 V AC). The device
may only be mounted, connected and
removed by qualified personnel.
Qualified personnel are persons who
are authorised to perform the
required tasks and recognise and
prevent possible dangers thanks to
their education, experience and
instruction in the relevant standards,
requirements and accidentprevention
regulations. The information and
instructions in this installation
manual must always be observed to
avoid danger and damage.
Installation
Installation of the wall display in
combination with a low voltage
device (power connection) should
only be carried out if you are certain
that the unit is isolated from the
power source.
Installation should be carried out in
accordance with the valid national
domestic installation guidelines, e.g.
NIN.
In particular, the directive NIN 4.9.1.ff is
valid if the wall display is to be
combined with a low voltage device
with power connection.
Combinations with low voltage
devices are only permitted if these
devices also have a simple basic
insulation.