Technical data

M217
6
Installation procedure
You should avoid applying
any pressure to the display
during or after installation.
1. Screw the mounting fixture (4)
onto the recessed or surface
mounted box
.
2. Strip the insulation off the
installation cable and feed it
through the mounting fixture (4).
3. Connect the cable to the
Phoenix screwed terminal
block.
4. Connect the terminal block with
the print connector on the back
of the operator panel (1)
5. Locate the operator panel (1) with
its frame (3) onto the mounting
fixture (4), so that the clip
connectors (2) on the panel (1)
line up with the cut-out (5) in the
mounting fixture (4).
6. Press the operator panel (1)
onto the mounting fixture (4)
until the clip connectors clip
into place.
DIP switches (back)
The basic settings are configured
with the DIP switches on the back of
the M217. Use a small screwdriver
for this purpose.