User manual

Configuration M230
6
Connection Setup
The access type and its specific
settings are selected here. You will find
the system requirements for this on
Page 3.
 Serial Port
Connection via serial RS232.
Directly available in the case of a
Re:system M10 or over a Re:connect
M200 and M203 interface, which is
connected with a Re:system device.
 USB Link
Connection via USB.
Cable type: USB A  B
Available in the case of Re:system M10,
M100 and M51 Mk2*
 TCP/ IP (recommended for M230)
 UDP/IP
Connection over a network - Ethernet
As the Revox Ethernet interface doesn't
support DHCP, the IP address has to be
entered directly. You will find a detailed
description of how to find out the
interface IP address on Page 7.
Directly available in the case of a
Re:system M10 or over a Re:connect
M202 Ethernet interface, which is
connected with a Re:system device**.
Important notes
* M51 Mk2 can be recognised from
the blue standby LED.
(M51 Mk1 = red LED)
** In a Multiroom System with
integrated slave devices (Re:system
M51 Slave, M100 Slave), each of the
slave devices also requires its own
M202 Ethernet interface as well as the
main device (Re:system M51, M100).
However, only the IP address of the
main device (Multiroom central unit) is
entered in the
Connection Setup . The IP
address of the slave devices is/are
automatically determined by the
Multiroom cabling of the M230.