Installation guide

M208 Manager
Re:control
12
Device Type
 Original RC28 [2]
Like with other Revox Remote Controls such as
the RC28 all commands of the M208 are being
send with RC5-product address, which have been
selected under M51 Select.
Example: M51 Select: AUX2
All buttons such as e.g. CH+ are being send as a RC5-
Code with the RC5 address Aux2. Softkeys can in the
RC28 adjustments not be defined.
 M37/ M57 Server [3]
With this adjustment the Menu of the Server will be
selected directly. This includes the synchronisation
routine. (Please verify the system requirements for
the Server-/Communication Module).
 Feller BEAMIT [4]
Choose this adjustment when you do have a light
control BEAMIT of Feller at home.
 Infrared (RC5) [5]
Choose this adjustment when the product does
contain product files (mpi-File) and IR-datas on a
RC5 basis. The used frequency is automatically
36kHz. The RC5-code is equipped with a Toggle-
Bit function.
 Infrared (RAW) [6]
This adjustments is to be chosen in case that the
product file (mpi-File) does contain IR-datas on a
RAW-basis. RAW datas define an IR code based
on:
- Frequency (IR_CARRIER), -
- Repetitions breakes (IR_PAUSE) and
- Rate of Repetitions (IR_REPEAT)
- Impulse-/ Pause-duration (IR_TIMEx)
The way and if at all an IR code is being repeated,
is defined in the mpi-File with the from Revox
developed syntax.
In the mpi-File the allocation of the Device Type is
done with figures:
0 = No Device
1 = M51 FM-Tuner
2 = Original RC28
3 = M37/ M57 Server
M51 SAT Module
With this adjustment the Menu of the SAT will be
selected directly. This includes the synchronisation
routine. (Please verify the system requirements for the
SAT- /Communication Module).
L
Further information to the creation of a product file mpi
you can get from the chapter product file mpi.
Browse
Normally all mpi-Files, which are needed during the
creation of a project can be copied out of the
Database Browser into the Project-Files under their
own names. From there they can be integrated into a
mpi-File.
Edit
The function Edit enables the user to modify the
shown mpi-File.
With Edit a text editors appears, which shows the
mpi-File:
After you have modified the mpi-file you can save the
file. Without saving the modified version all changes
will disappear when you close this window.
L
Further information concerning the creation of a
product file can be found in the chapter product-File
mpi.
4 = Feller Beamit
5 = Infrared RC5
6 = Infrared RAW
7 = M51 SAT Module