Technical data

M208 Re:control
K-1
K Appendix
Troubleshooting
Problem Possible remedy
No LCD display when
unit is touched
 Check the batteries and replace if necessary
 Check that the batteries are in the right way round
 Activate the movement sensor through the Setup Menu
Backlighting remains
dark
 Activate backlighting in the Setup Menu
 Backlight
 Is the brightness sensor covered?
 Is the ambient light too bright?  Setup Amb. Light
Display shows Card?
when a button is
pressed
 MMC memory card is not installed correctly or it is missing.
See Chapter MMC Card. You are not using an original
MMC card from Revox.
Synchronisation with
the M51 cannot be
carried out
 The connection through the M208 Link interface is faulty.
See Chapter Synchronisation.
 The M51 does not have the software that is needed to carry
out a synchronisation. See Technical Data.
A mechanical noise can
be heard from the M208
 There are two gold bearings in the M208’s movement
sensor that move against each other. This can be heard in a
very quiet environment and does not signify a fault.
The device to be
controlled does not
respond to the infrared
command
 With some M208 sources, not all buttons send infrared
codes. Please check in the Operating manual of the
corresponding device(s) to see whether the buttons send
infrared codes (grey border). Additionally, the display
shows the symbol
top right, if an infrared code is being
sent.
 The device cannot receive the infrared code because it is
too far away or because the transfer angle is too large. Try
again while standing nearer to the device and/ or hold the
remote control directly in front of the device.