Instruction Manual Video switch M300, M301

M300/ M301 Re:connect
8
Monitor connection panel
The monitor connection panel is
set out the same for the M300
and the M301 versions of the
video switch.
This is where you connect the
devices that reproduce the
picture. This can be an LCD or
plasma screen or a normal
television.
Further, these outputs are also
available with projectors and
beamers of course.
The television sound from the
TV source can be put through
the M51 using the Audio-IN
socket.
With a SCART connection,
these audio signals are already
integrated.
SCART output features
If your device is fitted with a
SCART input, this is the
recommended connection to
use as you can also output a
6/12 voltage through the
SCART connector. This
switching voltage automatically
switches on the TV device with
the correct input, once an RGB
signal is present from the M51
or the Video 5 or Video 6
sources.
A pre-quirement for this is that
Video mode has been set to
RGB+CVBS through the DVD
MKII module set-up.
This switching voltage is part of
the SCART standard and for this
reason, it doesn’t work with the
YC or YCrCb signals.
Parallel operation
Internally, and at the monitor
panel, the video switch uses
exceptionally clean and
powerful video amplifiers. This
means that several monitors
can be operated in parallel at
different outputs without
impacting on the quality of the
picture.
In this way for example, the
television can be connected
through SCART while the
projector can be fed with a
signal from the YCrCb output.