Technical data

I/O Module Re:source
3
Installation
The I/O plug-in card has the
most modern technology on it
and should be handled with
care.
Before you start to install the
card, the M51
must be switched
off and the power plug must be
removed from the power socket.
Any plug position can be
selected for the card, with the
exception of Slots 3 and 7
which are reserved for the DVD
and 5.1 Decoder cards
respectively.
Loosen the two screws with the
TORX screwdriver supplied and
remove the slot blanking plate.
Before removing the I/O module
from its packaging, make sure
that you are not charged with
any static electricity. This could
cause a damaging power
discharge when you touch the
module.
To be on the safe side, you
should discharge any static
from yourself by touching an
earthed metal object such as a
radiator.
Remove the I/O module from its
packaging and insert it into the
slot position, using the two
tracks within the M51 to guide it
into position. The lettering on
the card must be at the top. Just
before the card is fully inserted,
you will feel a certain
mechanical resistance as the
card meets the M51 contact
strip. Push the card fully home
by pushing in the area where
the 2 screw holes are located
and fix it in place with the two
screws.
All further steps needed to
integrate the new module into
the M51
will be carried out
automatically next time the unit
is switched on.