Technical data

DVS-5 Module
Re:source
3
Installation
The DVS plug-in card is
equipped with the latest in
electronics and should be
handled with care.
Before you install the card, the
M51 must be switched off and
separated from the power
supply, by plugging the unit out.
The DVS module has its own
plug-in position in slot 4 (the
fourth plug-in card from the
right when viewing the M51
from the back).
Loosen the two screws with the
TORX TX9 screwdriver (M51
accessory) and remove the
blanking plate.
Before removing the DVS
module from its packaging, make
sure that you are not charged
with any static electricity. This
could cause a damaging
discharge of voltage when you
touch the module. You should
get rid of any static charge by
touching an earthed metal object
like a radiator, for example.
Remove the DVS module from its
packaging and feed it into its
plug-in position. The two bars
inside the M51 are the
mechanical guides for you to use.
The lettering on the DVS plug-in
card must be on top. Shortly
before the plug-in card is fully
locked into position in its slot, you
will feel a clear mechanical
resistance, caused by the M51
contact strip. Push the DVS
module in by applying pressure in
the area of the two screw holes
and fix the card in place with both
screws.
All further steps for registering
the new module are carried out
automatically by the M51 the
next time it is switched on.