V1GW-4K Quick Start Guide
1. Overview 2. What’s in the box Thank you for choosing REXING! We hope you love your new product as much as we do. 1. 2. 3. 4. If you need assistance, or have any suggestions to improve it, please contact us. You can reach us via care@rexingusa.com or call us at (203) 800-4466. Our support team will respond you as soon as possible. Always a surprise in Rexing. Check us out here. https://www.facebook.com/rexingusa/ https://www.instagram.com/rexingdashcam/ https://www.rexingusa.
. Camera Overview 4. Installation Step 1: Install the Dash Cam 1. Place the 3M adhesive on the mount and properly orient the mount square to the roof and hood line of the vehicle. Important! Ensure the T-interlock on the Mount is oriented in the correct direction (as shown below). 2. 3. Firmly press the mount onto the windshield. Wait at least 20 minutes before mounting the camera. 4. Orientation mount as shown 5. 6. 10. 11. 12. 13. 8. 9. 7. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13.
You may now disconnect from power. The camera will shut down after 3 seconds. The camera should begin recording automaticially the next time it is powered on. Press the Power button to turn the power off Press the Menu button twice Step 3: Power the Camera and Format the Memory Card Power the camera by connecting the charger to the car cigarette lighter and camera. To ensure the V1GW-4K records to your memory card properly and without error.
Step 4: Installing the Camera onto the Windshield 5. Basic Operation Place the camera on the mount and carefully route the power cable around the windscreen and tuck in under the trim. Device Power Plug the Car Charger Cable into a 12V DC power outlet or the car cigarette lighter. The device is automatically powered on when plugged into a 12V accessory socket or cigarette lighter and receives a charge (i.e.: the vehicle is started.) Connect car charger to the camera.
Menu Settings Power the camera on. If the camear is recording, pres the REC button to stop recording. Press the MODE button and toggle to the desired mode. Video Recording The camera will automatically start recording when the device receives a charge. The LED lights and the red dot will blink when the device is recording. Press the REC button to stop recording. Press the MENU button once to enter the settings menu for a Mode. Press the MENU button twice to enter the System Settings.
During playback use the OK (pause), MIC (fast forward) and REC (rewind) buttons to control the video playback. To playback a video on the computer either use an SD card adapter or connect the device to the computer directly using the USB to Mini B 5pin male cable. Parking Monitor Connect the dash cam to the smart hardwire kit to activate the parking monitor function (Need to purchase the Smart Hardware Kit separately. ASIN: B07RN24B7V) Please visit support.rexingusa.com to watch a video tutorial.
GPS Logger Taking Photos GPS Signal (not connected) When connected to the camera, it will record the speed and location of your vehicle as you drive. You can then access this information while playing back your recordings using the GPS Video player (For Windows and Mac, available at rexingusa.com). Press the OK Button to take a photo. To view a photo, stop video recording and toggle to the Playback Mode. GPS Signal (searching) Press the MENU button twice and enter the System Settings.
FCCID: 2AW5W-V1GW This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
