User's Manual

6
3. Secure the dashcam to a place close to the original rearview mirror.
4. Plug the GPS module into the GPS port and secure the module to a
position close to A-pillar of the car. The antenna receiver side (the side
without 3M adhesive) faces the outside and the side with 3M adhesive faces
down. It should be properly secured.
5. Plug the charger into the car’s cigarette lighter. Connect the device to the
cigarette lighter through the car charger.
Note: The charger extension cable can be wired along the edge of the
windshield during installation. The optional rearview camera should be
mounted on the rear windshield of the car. Pay attention to its orientation
during installation. It can be wired against or above the interior’s headliner.
Plug the rearview camera connector into its rear camera port of the device
once the camera is securely mounted. Adjust the position of the lens to make
sure that it remains horizontal with the ground. Start the engine to check the
video operation of your device.
(This picture is for reference only. Listed articles should referred to your
actual device.)
6. Rearview Camera Wire Routing Illustration (as shown below)
Installation Instructions
Optimum Installation
Location
Power Cable
Wiring Location
Connection to rearview camera