User's Manual

RADIO AND TELEVISION INTERFERENCE
The equipment described in this manual generates, uses, and radiates radio-
frequency energy. If it is not installed and used correctly—it may cause inter-
ference with radio and television reception.
CE DECLARATION
This equipment has been tested and found to comply with the following har-
monised European Norms:
•EN300328 (radio and telecommunications terminal equipment)
•EN55024 (electromagnetic immunity) •EN55022 Class B (electromagnetic
emissions) •EN 60950 (electrical safety) •EN301489 (electromagnetic compat-
ibility and radio spectrum matters) Based on the results of these tests, Wireless
Corporation declares that the above mentioned devices conform to Article
10.1 of the European Council Directive 89/336/EEC, and their amendment
Directive 93/68/EEC, and to the Directive 1999/5/EC and indicates this con-
formity by the CE-sign on each device. The device must be installed and oper-
ated in strict accordance with the instructions given in this user manual. Any
changes or modications to this product that were not specically authorised
will invalidate this declaration.
FCC NOTICE
This equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
You can determine whether the equipment is causing interference by dis-
connecting power. If the interference stops, it was probably caused by the
equipment. If the equipment does cause interference to radio or television
reception, you may be able to correct the interference by using one or more
of the following measures:
•Rotate the television or radio’s antenna until the interference stops.
•Move the Wireless Microphone further away from the television or radio.
If necessary, consult your two way radio dealer or an experienced radio/
television technician for help. Changes or modications to this product not
authorized by the manufacturer could void the FCC Certication and negate
your authority to operate the product.
Notice : Changes or modications not expressly approved by the party for
compliance could void the user’s authority to operate the equipment.
IMPORTANT NOTE:
To comply with the FCC RF exposure compliance requirements, no change
to the antenna or the device is permitted. Any change to the antenna or the
device could result in the device exceeding the RF exposure requirements
and void user’s authority to operate the device.
Type Acceptance
18