Operation Manual

PAGE 8
• Scan
RM-03 allows optionally looking for carrier or carrier with CTCSS or
DCS. Your dealer can program those channels to be scanned on the
scan list.
Frequency/Channel Scan (Carrier Scan)
Press
button repeatedly until LCD shows “FREQ/CH SCAN?”,
then press
button to begin scanning per frequencies or per chan-
nels.
During scanning, press UP/DOWN button on the Mic or rotate power
knob to change scanning direction; press any button to stop scanning.
(except
button).
 When the transceiver is programmed with PA frequencies
and PB frequencies, in frequency mode (VFO), frequency subsec-
tion scan is valid. For more details, please refer to HELP options in
programming software.
CTCSS / DCS Scan (Tone Scan)
Press
button repeatedly till LCD displays “CTCSS/DCS
SCAN?”. Then press
to start scanning. When fi nding a match-
ing signaling, the scan will resume for 15 seconds. Press any key to
stop scanning.
 Tone Scan will be invalid if no sub audio tone is received in
current channel. Press Mic UP/DOWN or power knob to change
scanning direction.
• Monitor
This function allows you to override the squelch and the CTCSS
,DCS or 5 tone or listen to weak signal. Through PC programmer, you
can defi ne Monitor function to be operated as:
1. Keep pressing
button to open squelch and release it to stop
monitor. or
2. Press
one time to activate monitor function. Presss it again
to stop monitor.