Operation Manual

PAGE 12
knob to change scanning direction; press any button to stop scanning.
(except
button).
 When the transceiver is programmed with PA frequencies
and PB frequencies, in frequency mode (VFO), frequency subsec-
tion scan is valid. For more details, please refer to HELP options in
programming software.
CTCSS / DCS Scan (Tone Scan)
Press
button repeatedly till LCD displays “CTCSS/DCS
SCAN?”. Then press
to start scanning. When fi nding a match-
ing signaling, the scan will resume for 15 seconds. Press any key to
stop scanning.
 Tone Scan will be invalid if no sub audio tone is received
in current channel. Press Mic UP/DOWN or rotate power knob to
change scanning direction
• Priority Scan
In VFO mode, Priority scan will monitor the priority scan channel
once every 5 seconds.
1. In VFO mode, press button switch to channel mode. Then,
rotate power knob to select a channel as priority channel.
2. Press button repeatedly till LCD displays “PRIORITY
WATCH?”, then press button to start priority scanning.
 When the priority channel receives a matching carrier and
signaling, scanning will resume at priority scan channel for 10 sec-
onds. If you press PTT during this time, the priority scan will be
stopped and the radio will stay in this channel for communication.
• TX Power Selection
Keep pressing and then buttons or press H/L button at
extended Mic repeatedly to choose TX power among HIGH/MIDDLE/
LOW.
1. “TX POWER HIGH” indicates TX power is high.